If you find yourself having to reset your steering assist on a regular basis, it might be time to check out your settings. In this blog article, we will outline the different settings you can adjust and how they can affect your driving experience. From steering feel to turning radius, read on to learn more about how to get your steering assist back in line.
What is Steering Assist Reduced?
In some cars, the steering assist can be reduced to allow for a lighter hand when turning. This is generally done in an effort to improve fuel economy. If you experience Reduced Steering Assist, there are a few things that you can do to restore functionality.
1) Check to see if your car has a service manual. If not, you can generally find information on how to do this by looking online or contacting your car’s manufacturer.
2) Try resetting the system by turning the ignition off and then back on and waiting 10-15 seconds.
3) If steps 1-2 don’t work, you may need to take your car in for service.
How to Reset Steering Assist Reduced
If you are experiencing reduced steering assist, there are a few things that you can do to restore functionality.
First, check the fluid level in the steering assist motor. If it is low, add fluid to the reservoir until the level reads 3/4 full.
Next, remove the fuse for the steering assist motor located near the battery. This should disable the motor and allow you to reset it by turning it on and off several times while holding down the reset button.
If these steps fail to restore functionality, you may need to replace your steering assist motor.
How Much does it Cost to Reset Steering Assist Reduced?
If you’re experiencing reduced steering assist, it’s time to reset the system. The cost to reset the steering assist system is around $200-$300, depending on your vehicle.
To reset the steering assist system:
1. Turn off the car and remove the key from the ignition.
2. Disconnect all of the negative battery cables.
3. Remove any obstructions from under the car, including the radio antennae and air conditioning compressor hoses.
4. Raise and support the car with a jack so that it’s level and free of obstacles above it.
5. Disconnect all of the black/yellow electrical connectors from underneath the car (you’ll see at least six in total). You can also disconnect some of these connectors near or above where you removed obstructions earlier (these are labeled “PERR” or “PWR”).
6. Locate and unhook one of two large black/gray wire chains connected to each side of the steering column control unit (the unit nearest to where you removed obstructions earlier). Undo this connection by pulling it towards you while simultaneously holding on to one end with a wrench or pliers so that it doesn’t fall out of its mountings – don’t yank on it!
7. Carefully lower the control unit out of its mountings by slowly pushing down on one corner while rotating it counterclockwise until it stops at an angle, then
Conclusion
If you’re experiencing reduced steering assist from your vehicle’s electronic stability system (ESC), there are a few things you can do to try and resolve the issue. First, make sure that your tires are properly inflated and in good condition. Second, check to see if any debris is blocking the sensors on your ESC. Finally, if all of those tests come back negative and the issue still persists, it may be time for a replacement of your ESC.