Cerakote is a tough and durable coating made of polyurethane and curing agents. It’s commonly used on firearms and other metal surfaces to give them a high levels of protection. Cerakote trim coat is a specialized type of cerakote that is applied to firearms in order to protect the finish from wear and tear. The trim coat is applied when the firearm is still in its raw state, before it’s assembled or finished. Trim coat is often applied over unfinished cerakote, which can cause corrosion if not properly removed. Proper removal of trim coat can be a difficult process, as it can be adhered strongly to the firearm surface.
What is Cerakote?
Cerakote is a type of paint that’s designed to resist wear and tear. It’s also water resistant and has a high resistance to chemicals. This makes it perfect for use on firearms, knives, and other gear that could be subject to harsh environments or chemical attack.
To remove cerakote trim coat, you’ll need acetone, degreaser, steel wool, and a clean cloth. Begin by soaking the cloth in acetone for a few minutes. This will loosen the paint and make it easier to removed. Next, apply degreaser to the surface of the trim coat that you want to remove. Be sure to use enough degreaser so that it covers the entire area. Once the degreaser is fully dry, scrub the surface with steel wool until all of the paint is removed. Finally, rinse the area with clean water and dry off completely before applying a new finish or topcoat.
How to Remove Cerakote Trim Coat
Cerakote trim coat is a type of paint that is used on firearms. It is a two-part system that requires sanding and stripping before it can be removed. If the trim coat is not properly stripped, it can cause damage to the firearm. There are several ways to remove cerakote trim coat. Some people use a chemical stripper, others use a wire brush.
Tips for Removing Cerakote Trim Coat
When it comes to applying a new ceramic coating, there are a few things you should keep in mind. First and foremost is to be very careful when working with the trim coat. If you rush or make mistakes, you may end up with scratches or divots in your finish. Second, be sure to use a clean cloth and mild soap to clean the area before applying the sealer. Finally, use a hairdryer set on low heat to help smooth out any bumps or ridges in the finish.
Conclusion
If you’ve ever had the pleasure of working with a firearm that was finished in cerakote, you know that it’s one tough finish to remove. Most solvents and polishes will only work on the exterior of the metal, while leaving the Cerakote finish intact. Luckily, there is a method known as “subtractive stripping” which can be used to strip away all of the cerakote from firearms without damaging or removing any other finishes. If you’re interested in learning how to do this yourself, be sure to check out our article on how to remove cerakote trim coat.