When you’re working on your car, one of the most important things you need to know is how to put a Pulley on a Power Steering Pump. This simple task can save you time and hassle later on when it comes to fixing or replacing the pump. In this article, we will walk you through the process step by step, so that you can put a Pulley on your Power Steering Pump without any trouble.
Tools You’ll Need
If you’re replacing your power steering pump, it’s important to have the right tools. Here are the tools you’ll need:
-Pulley bolt (8mm)
-Power steering pump bolts (8mm, 10mm, 12mm)
-12mm wrench
-24 mm socket
-Extension arm
-Jack and jack stands
How to Put Pulley On Power Steering Pump
The following steps show how to put a pulley on a power steering pump. This is required when the pump becomes worn and needs to be replaced. The pulley will help to increase the speed at which the pump operates, thereby improving its efficiency.
1) Remove the cover from the power steering pump by removing the four screws that hold it in place.
2) Once the cover is removed, you will see the pulley and belt. The belt should be in good condition and should have no frays or breaks. If there are any defects, they can be fixed before installing the pulley by using a needle or seam ripper.
3) Place the pulley onto the belt and make sure that it is properly situated on both sides of the motor shaft. Make sure that it is tight against the shaft so that there is no movement of the pulley during operation.
4) Replace the cover onto the pump and screw it into place with the four screws that were removed earlier.
Tips for Putting Pulley On Power Steering Pump
If you are putting a pulley on your power steering pump, there are a few things to keep in mind. First, make sure the pulley is the correct size for the pump. Second, make sure the pulley is tight against the pump housing. Third, make sure the pulley isn’t rubbing against any other parts of the pump. Finally, make sure there are no sharp edges on the pulley or on the surrounding area.