If you own a car and use wheel locks to secure your wheels, then you’re probably familiar with the frustration of not being able to get them off. Wheel locks are one of those pieces of safety equipment that we take for granted, but they can be quite handy in a pinch. In this blog post, we will show you how to get wheel locks off without the key, so that you can safely remove them and keep your car safe.
Locking your wheel can keep you safe in the event of a fall
When it comes to safety, locking your wheel can keep you safe in the event of a fall. This is especially important if you have young children or pets around your vehicle. Here are four easy ways to get wheel locks off without the key:
1) Use a portable lock picker tool. Wheel locks can be broken with just a few deft strokes with a portable lock picker tool. Just be careful not to scratch the wheel!
2) Use a thin object to pry up on one side of the wheel lock. Pry slowly and evenly until the wheel lock pops off. Be sure to use caution when doing this so you don’t scratch the paint or metal on the wheel.
3) Use an automotive wrench. If you don’t have a portable lock picker tool or an automotive wrench, try turning the nut that holds the wheel lock on with a wrench. Be very careful not to damage the threaded part of the nut – just loosen it enough so that you can push down on the top of the wheel lock and pry it off.
4) Break into two pieces using brute force. If all else fails, try breaking into two pieces using brute force – be sure to wear gloves and eye protection!
There are two types of wheel locks – mechanical and electronic
There are two types of wheel locks – mechanical and electronic.
Mechanical wheel locks use a key to open the lock, whereas electronic wheel locks require a code to be entered into the lock before it will release.
Both types of wheel locks can be opened with common tools, but knowing how to get them off without the key is helpful in case you lose the key or want to keep your car locked while away.
Mechanical wheel locks use a screw to secure the wheel to the hub
One of the most common methods for securing a wheel to a hub is with a screw. Mechanical wheel locks use this method and typically come in either a key or non-key version. To remove mechanical wheel locks, you’ll first need to locate the screws that secure the wheel to the hub. Once you locate the screws, use a Phillips head screwdriver to remove them. Be careful not to lose these screws as they will be required in order to reattach the wheel later on.
Electronic wheel locks use a padlock to secure the wheel to the hub
The electronic wheel locks use a padlock to secure the wheel to the hub. To remove these locks, use a key or a tool that resembles the lock. First, unlock the wheel using the key. Next, disconnect the wire connected to the lock and pull it out of the hub. Finally, remove the lock by inserting a screwdriver into one side and prying it off.
To remove a mechanical wheel lock, you’ll need a wrench, ratchet, and some patience
If you’re looking to remove a mechanical wheel lock without the key, you’ll need a wrench, ratchet, and some patience. The procedure is as follows:
1. Locate the lock cylinder on the wheel. It will likely be located near the hub or center of the wheel.
2. Remove the lock cylinder by unscrewing it from the wheel. Be careful not to lose any screws!
3. Use the wrench to turn the ratchet counterclockwise until the lock cylinder loosens up from the wheel. Be careful not to over-torque the screw, or you may damage the wheel!
4. Once the lock cylinder is loose, use your fingers to remove it from the wheel. Make sure to clean off any dirt or debris that may have been attached to it during installation.
To remove an electronic wheel lock
If you have a wheel lock on your car, there are a few ways to remove it without the key. You can use a pick or lever tool to pry it off or you can use heat. If you don’t have access to either of those, you can use a cable cutter to cut the lock off.