It’s that time of year again: the weather is warm, the sun is shining, and roads are starting to get a little bit dusty. What could be better than hitting the open road this summer with your favorite tunes blasting out of your car’s speakers? Unfortunately, that means one thing: tires are going to start getting marks from gravel and dirt. And if you don’t take care of them, those tire marks will eventually turn into tire ruts. Fortunately, there’s a simple solution to removing tire marks from your driveway: use a plunger! Here are six steps on how to use a plunger to get tire marks off your driveway: ###
What Causes Tire Marks on Driveway?
Tire marks can be a common occurrence on driveways, especially if the driveway is used for vehicular traffic. There are a few factors that can contribute to tire marks on a driveway, including the weight of the vehicle, the type of pavement, and how the vehicle is driven.
One of the main factors that can contribute to tire marks on a driveway is the weight of the vehicle. The heavier the vehicle, the more pressure it will put down on the pavement. This pressure can cause divots in the surface, and eventually tire marks.
Another factor that can contribute to Tire Marks on Driveway is how the vehicle is driven. If the vehicle is driven too fast or erratically, it can create vibrations that will cause divots in the pavement. These vibrations also cause tires to leave prints in their wake.
Finally, one of the most common causes of Tire Marks on Driveway is rain or snow. When these elements fall upon a roadway, they cause water to seep into the asphalt and create potholes. The weight of vehicles then causes even more water to pool up and form into tire tracks
How to Remove Tire Marks from Driveway
There are a few ways to remove tire marks from a driveway, depending on the type of tire mark.
If the tire mark is made by a rubber or latex tire, use a stiff brush to scrub at the mark until it disappears. If the tire is made of metal, use a wire brush to scrape at the mark. Be sure to wear gloves and eye protection when scraping because metal filings can cause serious injury.
If the tire mark is made by a pothole, fill in the hole with fresh asphalt and then chip away at the old asphalt with a hammer.
What If Tire Marks are Deep?
If tire marks are deep, it may be difficult to remove them using household cleaners and a scrub brush. One option is to use a pressure washer. First, clean the area around the tire marks with a household cleaner. Next, spray the area with water from the pressure washer, and use the scrub brush to scrub the tire marks away. Finally, rinse the area with water.
Conclusion
If you’ve been noticing tire marks all over your driveway, there’s a quick and easy solution to removing them. Just use a bucket of hot water and some soap to scrub the tire marks off the driveway. Don’t fill up the bucket too high or you’ll end up scalding yourself; just enough so that the tire marks are slightly wet but not soaked. Let the area dry before driving on it again!