One of the most common accidents that happen in cars is someone forgetting to turn off their garage door opener. This can lead to serious problems if the door is left open while the car is inside, as it will cause the car to fill with carbon monoxide. There are a few quick and easy ways to erase your garage door opener from your car so that this doesn’t happen. Read on to find out how.
What You’ll Need
To erase your garage door opener from your car, you will need:
-A power drill
-A Phillips head screwdriver
-An eraser
-A piece of paper
1. Start by attaching the power drill to the vehicle’s battery and turning it on.
2. Once the drill is on, place the Phillips head screwdriver into the hole in the side of the garage door opener and turn it until it clicks into place.
3. Next, use the eraser to rub out any markings or prints made by the garage door opener onto your car’s surface.
4. Finally, write down your newly cleared serial number and store it somewhere safe for future reference.
How to Erase a Garage Door Opener In Car
Erasing a garage door opener in your car is easy. Follow these steps:
1. Park your car in the open garage.
2. Turn off the ignition and remove the key from the ignition.
3. Open your car door and remove any objects blocking the view of the opener controls.
4. Touch one of the white buttons on the control panel to turn on the power to the opener and wait for it to reset (about 5 seconds).
5. Touch one of the red buttons on the control panel to erase or write over your current code, if desired (this will set a new code for subsequent use).
6. Close your car door and re-insert your key into the ignition.
Tips for Erasing a Garage Door Opener in Car
When you need to erase a garage door opener from a car, follow these simple tips:
1. Remove the battery cover. This is usually located on the bottom of the opener near the ground. Pry it up with a Phillips or flathead screwdriver.
2. Disconnect the power cord and move the reset button to “off” position.
3. Use an eraser to lightly erase any identifying marks or numbers on the body of the opener. Be sure to avoid touching any moving parts!
4. Reconnect everything and test your new erased garage door opener by pressing the “open” button – it should work fine now!
Conclusion
If you’re ever feeling frustrated with your car’s garage door opener, there is a quick and easy way to erase it from your vehicle. All you need is some rubbing alcohol, a credit card, and a paperclip. First, place the rubbing alcohol on the Credit Card and carefully smooth it over the surface of the opener. Make sure that all of the edges are coated in rubbing alcohol. Then use the paperclip to clip off one end of the Credit Card so that it forms a loop. Put this loop over the top of the opening on your car and hold it in place while gently wiggling it back and forth until theCredit Card falls out ofthe loop (watch out for any sharp objects!). Finally,removethe paper Clip