Sunroof drains are a necessary part of most cars, but they can also be a bit of a hassle to replace. In this blog post, we will walk you through the necessary steps to replacing your sunroof drain tube. From finding the right part to installing it, everything you need to know is covered here. If you’re having trouble with your sunroof draining and need help fixing it, be sure to check out our website. We have experts on staff who will be happy to help you out.
Description of the Sunroof Drain Tube
One of the most common repairs that drivers make on their cars is fixing a leaky sunroof. A sunroof drain tube can become corroded and cause water to seep into the car, leading to an annoying wet spot on the dashboard. Follow these simple steps to replace a sunroof drain tube:
1) Remove the sunroof using your hands. If it is difficult to get off, use a flathead screwdriver to pry it off from the top.
2) Carefully remove the three screws that hold the drain tube in place.
3) Pull out the old drain tube and replace it with a new one. Make sure not to pinch any wires or cables as you do this.
4) Replace the screws and give your car a good clean up!
How to Replace a Sunroof Drain Tube
If you have a sunroof, there’s a good chance that the drain tube has become clogged. This can lead to water accumulation inside your car and eventually a hydroplaning situation. Here’s how to replace the drain tube:
1. Remove the sunroof liner using a Phillips head screwdriver. It’s held in place by six screws on each side.
2. Lift up the roof lining and locate the drain tube. It’s just below the roof lining and is secured by two clips on each side.
3. Pry off the clips with a flathead screwdriver and then pull out the drain tube. Clean it of any dirt or debris before replacing it with a new one. Tighten both clips back into place before re-installing the roof lining.
Tools Required for the Repair
To replace the sunroof drain tube, you’ll need a flat head screwdriver, a phillips screwdriver, and a T-bar removal tool.
1. Open the door and Locate the sunroof access panel. The panel is located on top of the dashboard, to the right of the climate control unit.
2. Remove the two Phillips screws that hold the panel in place.
3. Lift up on the dashed line that runs across the sunroof opening and pull out the panel.
4. Locate and remove the old drain tube from inside of the sunroof opening. Be sure to grab onto both ends of the tube so you can pull it out easily.
5. Slide in the new drain tube and reattach the two screws that hold it in place. Make sure to tighten them down evenly so there are no gaps between the tube and ceiling or wall surface.
Steps in the Repair
If you notice water dripping from your sunroof, it may be time to replace the drain tube. The process of replacing the tube is relatively simple, and can be done in just a few minutes.
Here are the steps involved:
1. Open your sunroof by gently pushing down on the roof rearward. Be sure not to pull too hard on the front or side panels, as this could damage them. If your panel has a wire mesh cover over the glass, remove it before opening the roof.
2. Find and remove the old drain tube by unscrewing it from its mounting bracket on either side of your sunroof. Make sure to retain both ends of the old tube – you’ll need them later when you reattach the new one.
3. Install the new drain tube by screwing it into place on either side of your sunroof using the original ends you retained from step 2. Be sure to tighten the screws evenly – if one side is tighter than the other, water will not flow properly through your roof and may cause leaks later on.
Conclusion
If your car’s sunroof is not draining properly, it may be due to a faulty drain tube. This guide will show you how to replace the tube in a simple and straightforward manner. If you have any further questions about replacing the drain tube on your car, be sure to consult a professional!